Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
- 3. The two-litre engine (ADY)
   3.1. Removal and installation
   + 3.2. Dismantling and assemblage
   - 3.3. A head of the block of cylinders and valves
      3.3.1. Removal of a head of the block of cylinders
      3.3.2. Dismantling of a head of the block of cylinders
      3.3.3. Repair of a head of the block of cylinders
      3.3.4. Assemblage of a head of the block of cylinders
      3.3.5. Installation of a head of the block of cylinders
      3.3.6. A hydraulic pusher
      3.3.7. Replacement of an epiploon of a camshaft
   + 3.4. Pistons and rods
   3.5. The block of cylinders
   + 3.6. A cranked shaft and radical bearings
   + 3.7. A mechanism drive газораспределения
   3.8. Tension adjustment приводного a belt of units of the engine
   3.9. An intermediate shaft
   3.10. Compression check in engine cylinders
   3.11. System of release of the fulfilled gases
   3.12. System of clearing with application of the activated coal
   3.13. System рециркуляции the fulfilled gases
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
+ 16. An electric equipment
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes

Folksvagen Sharan/Sharan repair>> The two-litre engine (ADY)>> Head of the block of cylinders and valves

Before to begin carrying out of any works in a head of the block of cylinders, familiarise with following general data on a mechanism design газораспределения:
- The camshaft having the top arrangement fastens on five bearings;
- The back bearing serves for an axial direction of a camshaft;
- Removed on earlier issued engines, for the purpose of engine greasing, the cover of the fourth bearing of a camshaft is established now again and is a usual cover of the bearing;
- Before spending processing of saddles of valves, necessarily read the recommendations resulted in item 3.3.3;
- The manufacturer in most cases does not specify the exact data for backlash check in the mechanism of a drive of valves, lengths клапанных springs in ненапряженном etc. If are doubts on the specified values it is necessary to address on HUNDRED Volkswagen where it is possible to receive more exact information;
- Plates клапанных springs, a spring and маслоотражательные caps are remote, as are in dredging of a head of the block of cylinders;
- At removal of valves pay attention to how these details have been established, on an arrangement of pushers, half of rod of the valve (crackers), plates of the valve, internal and external springs, маслоотражательных caps.