Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
- 3. The two-litre engine (ADY)
   3.1. Removal and installation
   + 3.2. Dismantling and assemblage
   + 3.3. A head of the block of cylinders and valves
   + 3.4. Pistons and rods
   3.5. The block of cylinders
   + 3.6. A cranked shaft and radical bearings
   + 3.7. A mechanism drive газораспределения
   3.8. Tension adjustment приводного a belt of units of the engine
   3.9. An intermediate shaft
   3.10. Compression check in engine cylinders
   3.11. System of release of the fulfilled gases
   3.12. System of clearing with application of the activated coal
   3.13. System рециркуляции the fulfilled gases
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
+ 16. An electric equipment
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes
Folksvagen Sharan/Sharan repair>> The two-litre engine (ADY)>> Intermediate shaft
Fig. 158. An intermediate shaft and its elements: 1 — a bolt, 40 Н·м; 2 — a washer; 3 — a cogwheel; 4 — an epiploon; 5 — the holder of an epiploon; 6 — an O-shaped sealing ring; 7 — segment шпонка; 8 — an intermediate shaft; 9 — a bolt, 25 Н·м





For removal of an intermediate shaft 8 (fig. 158) it is necessary to remove the engine from the car.
To remove an intermediate shaft, it is necessary to remove a drive of the oil pump as the pump is put in action by intermediate shaft. After removal of the distributor of ignition and parts of a drive of the mechanism газораспределения the intermediate shaft becomes accessible, bolts of its fastening it is possible to turn on and a shaft to take.
The flange of a sealing ring has a returnable aperture and should be established taking into account it. The flange defines an axial backlash of a shaft and should be replaced, if the axial backlash makes more than 0,25 mm. The O-shaped sealing ring creates tightness of a flange from outside the block of cylinders.
If the holder of an epiploon has been turned off, it is necessary to replace an epiploon with the new. Installation of an epiploon of an intermediate shaft is spent similarly to installation of a forward epiploon of a cranked shaft. Bolts of fastening of the holder of an epiploon at assemblage should be tightened the moment 25 Н·м.