Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
- 14. A back suspension bracket
   14.1. Removal and installation
   14.2. The longitudinal lever of a suspension bracket / of a spring of a suspension bracket — removal and installation
   14.3. Removal and installation of shock-absorbers
   14.4. Bearings of back wheels
+ 15. Brake system
+ 16. An electric equipment
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes
Folksvagen Sharan/Sharan repair>> the Back suspension bracket
Fig. 297. A back suspension bracket: 1 — a stretcher (a cross-section beam); 2 — the stabilizer of cross-section stability; 3 — a spring; 4 — the block of a nave of a wheel; 5 — the bottom lever; 6 — the shock-absorber





On fig. 297 the device of a back suspension bracket is shown. The back suspension bracket consists (from each party) of the bottom longitudinal lever, a screw spring, газонаполненного the shock-absorber and the stabilizer of cross-section stability. The wheel nave is established in the longitudinal lever. The longitudinal lever of a back suspension bracket fastens on a stretcher.
Shock-absorbers and springs are located between the bottom longitudinal levers and the car bottom. By cars with regulation of a road gleam (Nivomat) the special device which prevents the big deviations of height of the car at various loading is established.