Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
- 3. The two-litre engine (ADY)
   3.1. Removal and installation
   + 3.2. Dismantling and assemblage
   + 3.3. A head of the block of cylinders and valves
   - 3.4. Pistons and rods
      3.4.1. Removal
      3.4.2. Measurement of internal diameter of the cylinder
      3.4.3. Check of pistons and rods
      3.4.4. Gauging of a backlash of a rod
      3.4.5. Assemblage of pistons and rods
      3.4.6. Installation of pistons and rods
   3.5. The block of cylinders
   + 3.6. A cranked shaft and radical bearings
   + 3.7. A mechanism drive газораспределения
   3.8. Tension adjustment приводного a belt of units of the engine
   3.9. An intermediate shaft
   3.10. Compression check in engine cylinders
   3.11. System of release of the fulfilled gases
   3.12. System of clearing with application of the activated coal
   3.13. System рециркуляции the fulfilled gases
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
+ 16. An electric equipment
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes




Folksvagen Sharan/Sharan repair>> The two-litre engine (ADY)>> Pistons and rods>> Measurement of internal diameter of the cylinder

Fig. 60. The scheme of measurement of internal diameter of the cylinder: 1, 2 and 3 — the top, average and bottom belts of the cylinder; And, In — cross-section and longitudinal directions of measurement




Measurement of internal diameter of the cylinder is spent by the special measuring device — нутрометром in the top, average and bottom parts of the cylinder (rice 60 see). Measurements are spent in the same way, as well as on engine VR6 and should be spent some times (item 2.4.2 see).