Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
- 3. The two-litre engine (ADY)
   3.1. Removal and installation
   + 3.2. Dismantling and assemblage
   + 3.3. A head of the block of cylinders and valves
   + 3.4. Pistons and rods
   3.5. The block of cylinders
   - 3.6. A cranked shaft and radical bearings
      3.6.1. Removal of a cranked shaft
      3.6.2. Check of details of a cranked shaft
      3.6.3. Installation of a cranked shaft
      3.6.4. Epiploons of a cranked shaft
      3.6.5. Removal and flywheel installation (the car with mechanical КП)
      3.6.6. A privodnoj pulley of the hydrotransformer (for cars with АКП)
   + 3.7. A mechanism drive газораспределения
   3.8. Tension adjustment приводного a belt of units of the engine
   3.9. An intermediate shaft
   3.10. Compression check in engine cylinders
   3.11. System of release of the fulfilled gases
   3.12. System of clearing with application of the activated coal
   3.13. System рециркуляции the fulfilled gases
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
+ 16. An electric equipment
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes




Folksvagen Sharan/Sharan repair>> The two-litre engine (ADY)>> Cranked shaft and radical bearings>> Privodnoj pulley of the hydrotransformer (for cars with АКП)

Fig. 147. A privodnoj pulley of hydrotransformer AKP with details: 1 — подкладная a washer; 2 — a strengthening washer; 3 — a fastening bolt





The privodnoj pulley of hydrotransformer AKP fastens six bolts 3 (fig. 147) to a flange of a cranked shaft. Between bolts of fastening and приводным a pulley is the washer of strengthening 2 which has on an external edge скос and should be established it скосом in a direction to приводному to a pulley.
Installation приводного a pulley spend as follows:
- Attach приводной a pulley together with a washer of strengthening 2 to a flange of a cranked shaft six bolts of fastening 3 which should be turned by hand;
- Preliminary tighten fastening bolts приводного a pulley the moment 30 Н·м;

Fig. 148. Interval measurement between приводным a pulley and a surface of the block of cylinders





- Measure by a calliper distance from the block of cylinders to приводного a pulley (fig. 148). The received size should be in limits from 19,5 to 21,1 mm. If it not so establish подкладную a washer 1 (see fig. 147);
- Tighten bolts of fastening by the moment 60 Н·м then tighten them for 90 ° (on a turn quarter).