Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
- 15. Brake system
   + 15.1. Adjustment of brake system
   - 15.2. Disk brakes of forward wheels
      15.2.1. Check of a thickness of overlays brake колодок
      15.2.2. Removal and installation of lobbies brake колодок
      15.2.3. Dismantling and assemblage of the brake mechanism of a forward wheel
      15.2.4. Removal and installation of a brake support of forward wheels
   + 15.3. Brakes of back wheels
   15.4. Processing of brake disks
   + 15.5. The main brake cylinder
   15.6. Check of the vacuum amplifier of a brake drive
   15.7. Prorolling of brakes
   + 15.8. A lay brake
   + 15.9. System ABS (antiblocking brake system)
+ 16. An electric equipment
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes
Folksvagen Sharan/Sharan repair>> Brake system>> Disk brakes of forward wheels>> Removal and installation of a brake support of forward wheels
Bolts, крепящие brake supports, are wrapped by rather high moment of an inhaling: forward supports — 200 Н·м, back — 110 Н·м. Bolts of fastening of brake supports can be used further, carefully them having cleared. In case of replacement of bolts of fastening use only firm bolts from Volkswagen.
Removal of a brake support spend in a following order:
- ослабьте bolts of fastening of forward wheels, put a forward part of the car on a support and remove wheels;
- Remove brake колодки and tie up to a body a piece of a wire a brake support;
- If it is necessary, disconnect a brake hose from the cylinder case;
- Turn out the top and bottom bolts of fastening of a brake support to a rotary fist.
Installation of a brake support spend in an order, the return to removal, thus:
- Bolts of fastening of a brake support to a rotary fist tighten the moment 200 Н·м;
- Watch that the brake hose has not been overwound or will bend and did not concern car details;
- After installation of a brake support restore level in a tank and pump over hydrodrive system.