Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
- 15. Brake system
   + 15.1. Adjustment of brake system
   + 15.2. Disk brakes of forward wheels
   + 15.3. Brakes of back wheels
   15.4. Processing of brake disks
   + 15.5. The main brake cylinder
   15.6. Check of the vacuum amplifier of a brake drive
   15.7. Prorolling of brakes
   + 15.8. A lay brake
   + 15.9. System ABS (antiblocking brake system)
+ 16. An electric equipment
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes

Folksvagen Sharan/Sharan repair>> Brake system>> Processing of brake disks
If at check of a condition of a brake disk it will be found out that on its working surface there are teases and deep risks, and also other damages, прошлифуйте or pierce a brake disk again to make their serviceable. Both parties of a brake disk should be processed on identical depth, both parties of a disk should be parallel each other, and the thickness of a disk should not be less than 23,0 mm for a forward disk and 8,0 mm — for back.
Check up axial palpation of a working surface of a brake disk, without removing it from the car, by means of the measuring device on an external edge. For what establish a pin of the measuring device on distance about 5 mm from external edge of a brake disk and slowly twist a disk. If palpation more admissible, replace a disk or прошлифуйте it.