Repair VW Sharan. Diesel engines: 1,9 l TDI.+ 1. Introduction + 2. Engine VR6 + 3. The two-litre engine (ADY) + 4. System of greasing of the engine + 5. Cooling system + 6. System of injection of fuel of engine VR6 + 7. System Simos of injection of fuel of the 2,0-litre engine + 8. Ignition system + 9. Coupling + 10. A mechanical 5-step transmission + 11. Shaft of a drive of wheels + 12. The steering hydraulic booster + 13. A forward suspension bracket + 14. A back suspension bracket - 15. Brake system + 15.1. Adjustment of brake system - 15.2. Disk brakes of forward wheels 15.2.1. Check of a thickness of overlays brake колодок 15.2.2. Removal and installation of lobbies brake колодок 15.2.3. Dismantling and assemblage of the brake mechanism of a forward wheel 15.2.4. Removal and installation of a brake support of forward wheels + 15.3. Brakes of back wheels 15.4. Processing of brake disks + 15.5. The main brake cylinder 15.6. Check of the vacuum amplifier of a brake drive 15.7. Prorolling of brakes + 15.8. A lay brake + 15.9. System ABS (antiblocking brake system) + 16. An electric equipment + 17. The diesel engine + 18. System of greasing of the diesel engine + 19. System of cooling of the diesel engine + 20. The power supply system of the diesel engine and turbocharger + Maintenance service card + Specifications and characteristics + Electroschemes |
Folksvagen Sharan/Sharan repair>> Brake system>> Disk brakes of forward wheels>> Check of a thickness of overlays brake колодок At braking loading on brake колодки forward disk brakes more than on back brake колодки. In this connection they wear out faster.
Before to change brake колодки, it is necessary to measure a thickness of overlays on brake колодках. Service life brake колодок is calculated approximately on 50 000 km of run of the car during which periodically check a thickness of overlays on brake колодках. Exists corrected that under adverse conditions of driving of an overlay of 1 mm brake колодки grinds off a minimum for 1000 km. Usually overlays serve much longer.
For a rough estimate of a thickness of overlays brake колодок which should be spent regularly, illuminate a portable lamp in an observation port of a support and visually estimate a thickness of overlays brake колодок.
For exact definition of a thickness of overlays brake колодок it is necessary to remove a forward wheel (поддомкратив a forward part of the car and having turned out крепящие a wheel bolts) and to measure a thickness external and internal brake колодки. If the thickness of an overlay together with brake колодкой makes 7 mm the border of deterioration of an overlay is reached and колодки it is necessary to replace. The thickness колодки without an overlay makes 5 mm and deterioration of an overlay till the thickness of 2 mm is limiting.
|
|