Headlights are regulated by rotation of adjusting screws which turn an optical element in vertical and horizontal planes. On HUNDRED exact adjustment of headlights with use of the special measuring device is made and only in a special emergency it is possible to make rough adjustment independently.

Rough adjustment of headlights spend in a following order:

- Put completely filled and equipped car on an equal horizontal platform in 5 m from a smooth wall or any screen so that the axis of the car to it was perpendicular;

- Make sure that pressure in tyres corresponds to norm;

- Rock the car sideways to establish springs of suspension brackets;

- Measure distance between the earth and the centres of headlights. Put these points on a wall and draw through their a straight line;

- Draw on a wall the second straight line, below the first on 5 sm;

- Draw on a wall precisely on the car centre a vertical straight line;

- Measure distance between the middle of the car and the centres of headlights (right and left). Note daggers on a wall this distance postponed from a vertical line to the right and to the left, on the first straight line (top);

- Precisely in 5 sm under these daggers (on the bottom straight line) there should be points of a bend of a beam of a passing light of headlights. (If it so it is not necessary to spend rough adjustment);

- Be convinced that headlights are in a starting position (on the switch «0»);

- Consistently, at first for the right headlight (the left is closed by a piece of a matter or a dark matter), and then for left (the right is closed) adjust screws light bunches of headlights;

- Access to adjusting screws opens from a motor compartment;

- Include ignition and a passing light of headlights;

- The adjusting screw of vertical development (on a headlight outer side) establish the bottom border of a beam of a passing light on the bottom horizontal straight line;

- The adjusting screw of horizontal development (on a headlight inside) establish a point of a bend of border of a passing light on a corresponding dagger;

- Thus correct adjustment of a headlight of headlights is reached automatically.

Nevertheless at the first possibility make exact adjustment of headlights on HUNDRED.

Good advice

Right after exact adjustment of headlights on HUNDRED (by means of the special device), mark drawing of beams of the adjusted headlights on a door of the garage, precisely having put the car on distance of five metres from a garage door so that the car axis was perpendicular to it. The distance should be precisely measured, instead of is estimated approximately. Include a headlight of headlights and mark with daggers on a door of garage the centres of beams of light of both headlights.

Now at carrying out of rough adjustment of headlights it will be possible to take advantage of the put marks. It is necessary to put the car in the same position before a door of garage and to check up, whether the centres of beams of light of headlights coincide with the labels made earlier, and in need of them to adjust.