Service, the device and Folksvagen Sharan repair - 16.5.2. Removal and headlight installation

Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
- 16. An electric equipment
   + 16.1. The storage battery
   + 16.2. The generator
   + 16.3. A starter
   + 16.4. Screen wipers
   - 16.5. Headlights
      16.5.1. Replacement of lamps of headlights
      16.5.2. Removal and headlight installation
      16.5.3. Dismantling and headlight assemblage
      16.5.4. Headlight adjustment
   16.6. Back lanterns
   16.7. Replacement of lamps of forward indexes of turn
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes

Folksvagen Sharan/Sharan repair>> Electric equipment>> Headlights>> Removal and headlight installation

Headlight removal spend in a following order:

- Remove the turn index near to a headlight (see подразд. 16.7);

- Remove a radiator lattice:

- Turn away four bolts of fastening of a lattice of a radiator;

- Squeeze out the top part of a lattice of a radiator outside and remove it from the bottom fastening.

- In a motor compartment remove a protective cover of a headlight;

- Disconnect the electric socket located from the back party of a headlight;

- In front turn away four screws of fastening of a headlight (two from above and two from below) and remove a headlight in gathering in a direction forward.

Headlight installation spend in an order, the return to removal. Pay attention to that the outer side of a headlight with directing densely adjoined to a wing edge. Tighten screws of fastening of a headlight the moment 8 Н·м. After headlight installation check up and if necessary make adjustment of headlights. We recommend to make adjustment of headlights on HUNDRED.