Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
- 16. An electric equipment
   + 16.1. The storage battery
   + 16.2. The generator
   + 16.3. A starter
   + 16.4. Screen wipers
   - 16.5. Headlights
      16.5.1. Replacement of lamps of headlights
      16.5.2. Removal and headlight installation
      16.5.3. Dismantling and headlight assemblage
      16.5.4. Headlight adjustment
   16.6. Back lanterns
   16.7. Replacement of lamps of forward indexes of turn
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes
Folksvagen Sharan/Sharan repair>> Electric equipment>> Headlights>> Dismantling and headlight assemblage
Fig. 350. Separate elements of a headlight: 1 — the screw, 8 Н·м; 2 — a lock clip; 3 — the headlight case; 4 — the ventilating device; 5 — a cover; 6 — a cartridge of a lamp of dimensional light; 7 — двухнитевая a lamp, H4; 8 — a lamp накаливания dimensional light; 9 — a reflector; 10 — a rubber sealing lining; 11 — рассеиватель headlights; 12 — the fastening screw; 13 — the electric motor turning a reflector of a headlight





There is no necessity completely to replace a headlight if will break it рассеиватель or the reflector will be damaged. The headlight can be disassembled on components (fig. 350 see). Headlight dismantling spend in a following order:
- Remove the forward index of turn;
- Remove a radiator lattice;
- By means of a screw-driver cautiously remove five clips of fastening рассеивателя which are located on its perimetre;
- Remove рассеиватель headlights and a rubber sealing lining.
Headlight installation spend in an order, the return to dismantling, carrying out following recommendations:
- Do not concern a reflector barehanded;
- Always replace a rubber sealing lining рассеивателя headlights;
- Fastening clips рассеивателя establish manually on former places;
- After headlight installation necessarily spend its adjustment.