Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
- 16. An electric equipment
   + 16.1. The storage battery
   + 16.2. The generator
   + 16.3. A starter
   + 16.4. Screen wipers
   - 16.5. Headlights
      16.5.1. Replacement of lamps of headlights
      16.5.2. Removal and headlight installation
      16.5.3. Dismantling and headlight assemblage
      16.5.4. Headlight adjustment
   16.6. Back lanterns
   16.7. Replacement of lamps of forward indexes of turn
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes
Folksvagen Sharan/Sharan repair>> Electric equipment>> Headlights>> Replacement of lamps of headlights
Lamps of headlights act in film from outside a motor compartment of the engine. Replacement of a lamp does not change юстировку a headlight.

The prevention
At replacement of lamps of headlights work in gloves that on lamp glass does not remain fatty traces from fingers as even insignificant fatty traces on a burning lamp lead to dimness of a flask and a fast exit of a lamp out of operation. If such traces are, remove their spirit.

Replacement of a lamp of a headlight is spent in a following order:

Fig. 351. A kind of a headlight from the back party: 1 — a clip; 2 — an electric socket; 3 — a cartridge of a lamp of a dimensional lantern; 4 — a headlight lamp; 5 — a clip clamp




Fig. 350. Separate elements of a headlight: 1 — the screw, 8 Н·м; 2 — a lock clip; 3 — the headlight case; 4 — the ventilating device; 5 — a cover; 6 — a cartridge of a lamp of dimensional light; 7 — двухнитевая a lamp, H4; 8 — a lamp накаливания dimensional light; 9 — a reflector; 10 — a rubber sealing lining; 11 — рассеиватель headlights; 12 — the fastening screw; 13 — the electric motor turning a reflector of a headlight




- Remove from outside a motor compartment a protective cover 5 (fig. 350 see). For this purpose turn a cover to the left and remove it. Now the headlight looks like, shown on fig. 351;
- Separate an electric socket 2 from the back party of a headlight;
- Press a clamp 5 clips 1 and cast away a clip downwards;
- Take a lamp of a headlight 4;
- Establish a new lamp (work in gloves). At installation of a lamp "ledges" on a lamp socle should enter into fillets on a reflector;
- Put on a clip 1 a socle of a lamp and latch a clamp 5;
- Put on a cover and turn it clockwise.
After replacement of a lamp of a headlight check up and if necessary make adjustment of headlights. We recommend to make adjustment of headlights on HUNDRED.
Replacement of a lamp of dimensional light
Replacement of a lamp of dimensional light is spent in a following order:
- Remove from outside a motor compartment a protective cover;
- Take a cartridge 3 (fig. 351 see) with a lamp of dimensional light and штекерной колодкой from the headlight case;
- Replace a faulty lamp and move a cartridge with a new lamp and штекерной колодкой into a reflector;
- Put on a protective cover and turn it clockwise.