Fig. 352. Details of a back lantern: 1 — a rubber sealing lining; 2 — a lamp накаливания the turn index, 21 In; 3 — a cartridge of lamps накаливания; 4 — a lamp накаливания back dimensional light, 21 In; 5 — двухнитевая a lamp of a stoplight and back dimensional light, 21/5 Vt; 6 — a nut, 6 Н·м; 7 — рассеиватель a lantern

In the case of back lanterns with right and a car left-hand side there are lamps накаливания back dimensional light 4 (fig. 352), stoplights 5 and indexes of turn 2.

Other additional lamps are on a back door on the average the block of lighting devices.

Replacement of lamps накаливания back lanterns

Replacement of lamps накаливания back lanterns spend in a following order:

- By means of a screw-driver remove clip-on earrings of an internal upholstery of a luggage carrier (in a salon corner, on the right or to the left of a luggage carrier);

- Remove an internal upholstery of a luggage carrier in a corresponding corner of salon;

Fig. 353. A back lantern from the inside: 1 — the lock; 2 — a fastening nut

- By means of a screw-driver translate the lock 1 (fig. 353) so that it was possible to pull out a payment in gathering;

- Press a faulty lamp and, having turned counter-clockwise, take from a cartridge;

- Insert into a cartridge a new lamp (holding a napkin) and turn clockwise before fixing.

Fig. 354. Removal of the case of a back lantern

If it is required to remove all case of a back lantern turn on from within bodies a key «on 8 mm» three nuts (fig. 354, it is shown by an arrow) fastenings of a back lantern. Outside of a body remove a back lantern and its rubber sealant. If a sealant porous it is necessary to replace it in order to avoid hit of a moisture in the car.

The average block of back lighting devices

Fig. 355. The average block of back lighting devices: 1 — a lamp of a lantern of a backing; 2 — a lamp cartridge; 3 — a lamp of a back antifog lantern; 4 — a lamp of a lantern of a backing; 5 — a lamp cartridge; 6 — a rubber sealing lining; 7 — glass of group of lighting devices; 8 — a lantern of illumination of licence plate; 9 — a lamp of a lantern of illumination of licence plate; 10 — рассеиватель a lantern of illumination of licence plate; 11 — the screw

The block of lighting devices located on a door of a luggage carrier of car Sharan includes lamps накаливания lanterns of a backing 1 and 4 (fig. 355) and lamps of 3 back antifog lanterns.

Removal of the block of lighting devices is made in a following order:

- Open a luggage carrier door, turn out nine screws of fastening of an upholstery of a door and remove an upholstery downwards;

- Disconnect electric sockets from both payments with lamps on the right and at the left, having hooked their screw-driver;

Fig. 356. Places of fastening of the average block of lighting devices (are shown by arrows)

- Turn away nine nuts (fig. 356) fastenings of the block of lighting devices to a luggage carrier door;

- Close a door of a luggage carrier and remove the block of lighting devices together with rubber sealing linings in a direction on itself.

Installation of the block of lighting devices is made in an order, the return to removal, taking into account the following:

- Tighten nine nuts of fastening of the block in regular intervals on a circle the moment 6 Н·м;

- Pull from below an internal upholstery of a door of a luggage carrier so that apertures have coincided and tighten screws on a circle;

- The porous or damaged rubber sealing lining replace on new in order to avoid hit of a moisture in the car.

Replacement of lamps of illumination of licence plate

Replacement of a lamp of illumination of licence plate spend in a following order:

- Turn out two screws 11 (fig. 355 see) fastenings рассеивателя 10 lanterns of illumination of licence plate;