Repair VW Sharan. Diesel engines: 1,9 l TDI.+ 1. Introduction + 2. Engine VR6 + 3. The two-litre engine (ADY) + 4. System of greasing of the engine + 5. Cooling system + 6. System of injection of fuel of engine VR6 + 7. System Simos of injection of fuel of the 2,0-litre engine + 8. Ignition system + 9. Coupling + 10. A mechanical 5-step transmission + 11. Shaft of a drive of wheels + 12. The steering hydraulic booster + 13. A forward suspension bracket + 14. A back suspension bracket - 15. Brake system + 15.1. Adjustment of brake system + 15.2. Disk brakes of forward wheels - 15.3. Brakes of back wheels 15.3.1. Check of a thickness of overlays brake колодок 15.3.2. Replacement brake колодок 15.3.3. Dismantling and assemblage of the brake mechanism of a back wheel 15.4. Processing of brake disks + 15.5. The main brake cylinder 15.6. Check of the vacuum amplifier of a brake drive 15.7. Prorolling of brakes + 15.8. A lay brake + 15.9. System ABS (antiblocking brake system) + 16. An electric equipment + 17. The diesel engine + 18. System of greasing of the diesel engine + 19. System of cooling of the diesel engine + 20. The power supply system of the diesel engine and turbocharger + Maintenance service card + Specifications and characteristics + Electroschemes |
Folksvagen Sharan/Sharan repair>> Brake system>> Brakes of back wheels>> Check of a thickness of overlays brake колодок Before to change brake колодки back wheels, it is necessary to measure a thickness of overlays on brake колодках. At brake колодок service life approximately on 50 000 km of run of the car during which periodically check a thickness of overlays on brake колодках. Exists corrected that under adverse conditions of driving of an overlay of 1 mm brake колодки grinds off a minimum for 1000 km. Usually overlays serve much longer.
For a rough estimate of a thickness of overlays brake колодок which should be spent regularly, illuminate a portable lamp in an observation port of a support and visually estimate a thickness of overlays brake колодок.
For exact definition of a thickness of overlays brake колодок it is necessary to remove a back wheel (поддомкратив a back part of the car and having turned out крепящие a wheel bolts) and to measure a thickness external and internal brake колодки.
If the thickness of an overlay together with brake колодкой makes 7 mm the border of deterioration of an overlay is reached and колодки it is necessary to replace. The thickness колодки without an overlay makes 5 mm and deterioration of an overlay till the thickness of 2 mm is limiting.
|
|