Repair VW Sharan

. Diesel engines: 1,9 l TDI.
- 1. Introduction
   1.1. New VW Sharan
   1.2. Car identification
   1.3. The general recommendations about car repairs
   1.4. Conditions of work and the used tool
   1.5. Correct lifting of the car
   - 1.6. Works on repair and service
      1.6.1. Check of level of engine oil and its replacement
      1.6.2. Check of level of a brake liquid
      1.6.3. Check of work of stoplights
      1.6.4. Check of work of system of illumination
      1.6.5. Pressure check in tyres
      1.6.6. Check of the air filter
      1.6.7. Check of level of a cooling liquid
      1.6.8. Check of level of a liquid in the steering hydraulic booster
   1.7. Lubricants, hermetics, Loctite
   1.8. Rules of the reference with carving connections, bolts, nuts
+ 2. Engine VR6
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
+ 16. An electric equipment
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes


online


Folksvagen Sharan/Sharan repair>> Introduction>> Works on repair and service>> Pressure check in tyres
Pressure of air in tyres is checked by a manometre and if necessary pumped up by the small electric pump which is connected to a socket прикуривателя. Pressure is necessary for checking always on cold tyres as during driving the tyre is warmed up. In warm tyres pressure of air can appear above on 20 — 30 кПа. At all do not lower thus pressure in tyres.
Pressure size in cold tyres, at normal loading the following:
- For tyres of the size 195/65 R15Т:
 Lobbies — 260 кПа
 Back — 240 кПа
- For tyres of the size 215/60 R15H:
 Lobbies — 230 кПа
 Back — 210 кПа
Pressure in tyres should be checked regularly — every month. If pressure in tyres falls on 1,5 % a month this normal phenomenon, at большей to size is necessary to establish the reason. Probably, air leak occurs through a gate zolotnik. If pressure of air in the tyre constantly falls at a serviceable zolotnik, that, using special hermetic, repair the tyre. For installation of tyres are necessary special skill and knowledge to avoid damages of a board of a tyre cover (infringement of tightness of the tyre). Therefore installation of tyres is recommended to be carried out on HUNDRED which have for these purposes the necessary equipment. After installation of tyres follows отбалансировать wheels.

Fig. 6. The recommended tool and auxiliaries: 1 — a butterdish; 2 — a hydraulic jack; 3 — an electric portable lamp; 4 — подставные support; 5 — динамометрический a key; 6 — small ножовка; 7 — a wire brush; 8 — a control lamp (12); 9 — a measuring instrument of depth of a profile of tyres; 10 — a manometre for pressure measurement in tyres; 11 — a set measuring щупов




Fig. 11. Check of depth of a profile of the tyre




After certain run it is necessary to check up residual depth of a profile of the tyre. Manufacturers of tyres have made for this purpose the small special tool 9 (fig. 6 see) — a measuring instrument of depth of a profile of the tyre which is established on the tyre, as is shown in fig. 11. Being based on its indications, it is possible to learn residual height of drawing of a protector which according to traffic Rules should not be less, than 1,6 mm.