Repair VW Sharan. Diesel engines: 1,9 l TDI.- 1. Introduction 1.1. New VW Sharan 1.2. Car identification 1.3. The general recommendations about car repairs 1.4. Conditions of work and the used tool 1.5. Correct lifting of the car + 1.6. Works on repair and service 1.7. Lubricants, hermetics, Loctite 1.8. Rules of the reference with carving connections, bolts, nuts + 2. Engine VR6 + 3. The two-litre engine (ADY) + 4. System of greasing of the engine + 5. Cooling system + 6. System of injection of fuel of engine VR6 + 7. System Simos of injection of fuel of the 2,0-litre engine + 8. Ignition system + 9. Coupling + 10. A mechanical 5-step transmission + 11. Shaft of a drive of wheels + 12. The steering hydraulic booster + 13. A forward suspension bracket + 14. A back suspension bracket + 15. Brake system + 16. An electric equipment + 17. The diesel engine + 18. System of greasing of the diesel engine + 19. System of cooling of the diesel engine + 20. The power supply system of the diesel engine and turbocharger + Maintenance service card + Specifications and characteristics + Electroschemes |
Folksvagen Sharan/Sharan repair>> Introduction>> Correct lifting of the car Car lifting is carried out by means of a jack from the complete set of the driver's tool, a garage jack or the stationary lift on HUNDRED. Installation sites of a jack from each party of a body have the corresponding strengthened seats. For a raising of a forward part of the car the jack should be established under the strengthened seat (fig. 7).
Before to carry out car lifting tighten a lay brake and enclose an emphasis under a forward and back wheel from a car opposite side.
At use of a garage jack or the lift use the same points of lifting on a car body.
Be necessarily convinced of that a ground under a jack or support firm enough, and support will not leave in the earth under weight of the car. To avoid it under a heel of an added jack or under wheels of a garage jack it is possible to enclose a wide board which will not allow them to plunge into the earth.
Before lifting of a back part of the car include a reverse gear on a mechanical transmission or establish the selector lever in position «Р» of a parking on an automatic transmission.
Трехногие подставные support (fig. 8) can be established only under a lateral part of a body, but apply them follows cautiously, undertaking all measures not to damage a car body.
It is necessary to pay attention that the probe with which help the height of support is regulated, is enough прочен, therefore do not use instead of it other details, for example, bolts. Special supports (fig. 9) for wheels or a repair platform also are intended for carrying out of repair work under the car bottom.
At entrance on special supports be convinced that they are precisely before wheels to provide to the car at arrival a correct direction of movement. With a view of additional safety on such supports often do dredging for car wheels. It is necessary to remember that Sharan above the usual car, therefore it is less steady.
|
|