Repair VW Sharan

. Diesel engines: 1,9 l TDI.
- 1. Introduction
   1.1. New VW Sharan
   1.2. Car identification
   1.3. The general recommendations about car repairs
   1.4. Conditions of work and the used tool
   1.5. Correct lifting of the car
   + 1.6. Works on repair and service
   1.7. Lubricants, hermetics, Loctite
   1.8. Rules of the reference with carving connections, bolts, nuts
+ 2. Engine VR6
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
+ 16. An electric equipment
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes

Folksvagen Sharan/Sharan repair>> Introduction>> The general recommendations about car repairs
All descriptions in the present repair manual are clear enough and simple. The help tables resulted in the end of the book, are very important and should be used at work on repair and car service as at the description of separate processes in the book text all necessary sizes and the data are not always resulted, and this information should be specified under tables. Especially it is important at check of the data for concrete model to exclude error possibility.
At work on repair and car service carry out following recommendations:
- Screws and nuts should be pure and slightly greased. Always check a carving of nuts and bolts that on it there were no damages. If necessary use new screws or nuts;
- Always replace the removed self-stopped nuts with the new;
- Always observe the specified moments of an inhaling of carving connections. Values of the moments of an inhaling are broken on groups, according to sections of the present management that allows to find necessary sizes easily;
- At assemblage replace all sealing linings, epiploons, lock washers, шплинты and O-shaped sealing rings (round rings). Also it is necessary to replace sealing rings of shaft and radial consolidations of shaft, in a case if the shaft has been taken from a sealing ring. Before installation it is necessary to cover a surface of a sealing ring with greasing. At its installation it is necessary to pay attention to that the greased party looked in that direction, oil or greasing whence can follow;
- Special attention give to reliable fixing of the car in the lifted condition, using, whenever possible, трехногие подставные support;
- Greasing, oil, anticorrosive protection of the bottom of a body and all mineral substances aggressively operate on rubber parts of the chassis and brake system. It is impossible to suppose hits of similar substances, and also fuel, especially on rubber parts of hydraulic system. For clearing of brake system use only a brake liquid or spirit. However do not forget thus that the brake liquid can spoil a paint and varnish covering of the car;
- After repair carrying out necessarily it is necessary to check up serviceability of work of systems and car units at car movement.