Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
+ 16. An electric equipment
- 17. The diesel engine
   17.1. Removal and installation
   + 17.2. Dismantling and assemblage
   + 17.3. A head of the block of cylinders
   + 17.4. Privodnye belts — поликлиновой and gear
   + 17.5. Shatunno - piston group
   + 17.6. An intermediate shaft
   17.7. A flywheel
   - 17.8. A camshaft and a camshaft epiploon
      17.8.1. Camshaft removal
      17.8.2. Camshaft check
      17.8.3. A camshaft epiploon
      17.8.4. Installation of a camshaft and a camshaft epiploon in a head of the block of cylinders
   + 17.9. A cranked shaft and radical bearings
   + 17.10. The block of cylinders
   17.11. Compression check in engine cylinders
   17.12. System of release of the fulfilled gases
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes


экстрасенс Астрид запись на прием


Folksvagen Sharan/Sharan repair>> The diesel engine>> Camshaft and camshaft epiploon>> Camshaft epiploon

Fig. 437. Remove a sealing ring of a camshaft by means of a special stripper





The camshaft epiploon can be replaced on the established engine if near to it oil tracks have been covered up. The epiploon settles down behind a camshaft pulley. To avoid damage of a head of the block of cylinders or a camshaft the special tool is necessary for epiploon removal (fig. 437). The cam clings between a working edge of consolidation and a camshaft under an epiploon so the epiploon can be weakened and pulled out under the influence of the lever. The epiploon also can be removed by means of the oblique lever.
To get access to a camshaft, it is necessary to remove gear приводной a belt as it has been described in item 17.4.1.

Fig. 438. Bring down a camshaft cogwheel, having inserted behind оправку and shortly having struck on it a plastic or rubber hammer behind





Fix in motionless position a camshaft cogwheel (for example, by means of old gear приводного the belt which has been wrapped up round a cogwheel, or inserted in one of cogwheel apertures оправки) and turn away a cogwheel bolt. Take out a bolt and remove a washer. Bring down a cogwheel, having inserted into it behind оправку as it is shown on fig. 438.
By means of nippers take out segment шпонку from a camshaft.
In the described way remove an epiploon.