Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
+ 16. An electric equipment
- 17. The diesel engine
   17.1. Removal and installation
   + 17.2. Dismantling and assemblage
   + 17.3. A head of the block of cylinders
   + 17.4. Privodnye belts — поликлиновой and gear
   + 17.5. Shatunno - piston group
   + 17.6. An intermediate shaft
   17.7. A flywheel
   + 17.8. A camshaft and a camshaft epiploon
   + 17.9. A cranked shaft and radical bearings
   + 17.10. The block of cylinders
   17.11. Compression check in engine cylinders
   17.12. System of release of the fulfilled gases
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes


Редуктор давления воды по материалам honeywell-rus.ru.
atoll excellence l 17
Купить trx киев смотрите на www.trxtraining.com.ua.


Folksvagen Sharan/Sharan repair>> The diesel engine>> System of release of the fulfilled gases
Though the system of release of the fulfilled gases of the diesel engine differs from similar system of the petrol engine, nevertheless basically to it all recommendations which have already been given at the description of system of release of the fulfilled gases of the petrol engine are applicable.
The structure of system of release of the fulfilled gases includes turbocharger, a radiator of forced air and system рециркуляции the fulfilled gases (EGR).
The exhaust pipe is attached to a branch pipe for tap of gases turbochargerа. Behind a forward exhaust pipe the catalyst which is connected with the average muffler is located.
Further some additional recommendations about work about removal and installation of details of system of release of the fulfilled gases:
- The catalyst fastens to the average muffler by means of clamping скобы, and a forward exhaust pipe by means of three bolts with nuts;
- Do not use at joining of parts of system of release of the fulfilled gases in front of the catalyst any герметизирующих means for additional consolidation of connections;
- In places of connections use new nuts and linings;
- At fastening of system of release of the fulfilled gases pay attention to that rubber collars of a suspension bracket of system of release of the fulfilled gases were not in pressure, otherwise they will quickly become unfit for use.
After installation be convinced that all details of system of release of the fulfilled gases are on sufficient removal from other parts of the car.