Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
- 15. Brake system
   + 15.1. Adjustment of brake system
   + 15.2. Disk brakes of forward wheels
   + 15.3. Brakes of back wheels
   15.4. Processing of brake disks
   - 15.5. The main brake cylinder
      15.5.1. Removal and installation of the main brake cylinder
      15.5.2. Repair of the main brake cylinder
   15.6. Check of the vacuum amplifier of a brake drive
   15.7. Prorolling of brakes
   + 15.8. A lay brake
   + 15.9. System ABS (antiblocking brake system)
+ 16. An electric equipment
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes
Folksvagen Sharan/Sharan repair>> Brake system>> The main brake cylinder>> Repair of the main brake cylinder
Fig. 327. Fastening of the main brake cylinder: 1 — a cover of a tank with plugs of the gauge of emergency level of a brake liquid; 2 — a float; 3 — a tank; 4 — connecting plugs; 5 — a nut, 25 Н·м; 6 — the main brake cylinder; 7 — a sealing ring; 8 — a flange of fastening of a tip of a hose; 9 — the vacuum amplifier





Repair of the main brake cylinder in case of malfunction consists in its replacement in gathering on the new. The unique elements which are subject to replacement, are the connecting plug 4 (fig. 327 see), in case of detection of traces of leak of a liquid, and a sealing ring 7 between the main brake cylinder and the vacuum amplifier.
At replacement of connecting plugs execute following operations:
- Open a cover of a tank and by means of a siphon-pear pump out from it a liquid;
- By means of a screw-driver shake to the right-to the left a tank and cautiously remove it;
- Take connecting plugs;
- New connecting plugs grease with a brake liquid and insert them into the main brake cylinder;
- Cautiously establish a tank;
- Restore liquid level in a tank and pump over hydrodrive system.