Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
+ 16. An electric equipment
- 17. The diesel engine
   17.1. Removal and installation
   + 17.2. Dismantling and assemblage
   + 17.3. A head of the block of cylinders
   + 17.4. Privodnye belts — поликлиновой and gear
   + 17.5. Shatunno - piston group
   + 17.6. An intermediate shaft
   17.7. A flywheel
   + 17.8. A camshaft and a camshaft epiploon
   + 17.9. A cranked shaft and radical bearings
   - 17.10. The block of cylinders
      17.10.1. Measurement of apertures of cylinders
      17.10.2. Check up привалочную a surface of the block of cylinders
   17.11. Compression check in engine cylinders
   17.12. System of release of the fulfilled gases
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes




Folksvagen Sharan/Sharan repair>> The diesel engine>> The block of cylinders>> Check up привалочную a surface of the block of cylinders

Fig. 402. Check of a head of the block of cylinders on deformation by means of a measuring ruler and щупа





Surface of the block of cylinders check up on deformation by the way similar to check of a head of the block of cylinders (fig. 402 see). Measure the block of cylinders in a longitudinal, cross-section direction and on a diagonal. Thus should not enter щуп in the thickness more than 0,1 mm.