Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
+ 16. An electric equipment
- 17. The diesel engine
   17.1. Removal and installation
   + 17.2. Dismantling and assemblage
   + 17.3. A head of the block of cylinders
   + 17.4. Privodnye belts — поликлиновой and gear
   + 17.5. Shatunno - piston group
   - 17.6. An intermediate shaft
      17.6.1. Removal
      17.6.2. Installation
   17.7. A flywheel
   + 17.8. A camshaft and a camshaft epiploon
   + 17.9. A cranked shaft and radical bearings
   + 17.10. The block of cylinders
   17.11. Compression check in engine cylinders
   17.12. System of release of the fulfilled gases
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes




Folksvagen Sharan/Sharan repair>> The diesel engine>> Intermediate shaft>> Installation

Fig. 434. Выпрессовка an epiploon from a flange of an intermediate shaft





If the flange has been turned off, it is necessary to replace the sealing ring located on an inside of a flange. To beat out an old sealing ring, put a flange on a vice (fig. 434) Zapressujte a new sealing ring.
For installation of a sealing ring establish at first a shaft, and after that впрессуйте a sealing ring as it has been described for a forward epiploon of a cranked shaft. Bolts at assemblage should be tightened the moment 25 Нм.
Establish a cogwheel on intermediate to a shaft so that the wedge has entered шпоночный a groove. Thanks to it the cogwheel will be established in correct position.
Insert a bolt and a washer and tighten a bolt, keeping thus a cogwheel in a motionless condition (for this purpose insert оправку into an aperture on a cogwheel and rest оправку against a surface of the block of cylinders) the moment 45 Нм.
Other operations are spent to sequences, return to removal process.