Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
- 16. An electric equipment
   + 16.1. The storage battery
   - 16.2. The generator
      16.2.1. Safety measures at work in electrical supply system
      16.2.2. Generator check
      16.2.3. Removal and generator installation
      16.2.4. Generator repair
   + 16.3. A starter
   + 16.4. Screen wipers
   + 16.5. Headlights
   16.6. Back lanterns
   16.7. Replacement of lamps of forward indexes of turn
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes
Folksvagen Sharan/Sharan repair>> Electric equipment>> The generator>> Removal and generator installation
Fig. 334. Details of the generator and its fastening on the 2,0-litre engine: 1 — bolts М8, 25 Н·м; 2 — a tension roller; 3 — an arm; 4 — натяжительное the device; 5 — nut M8, 30 Н·м; 6 — a pressure regulator; 7 — bolts of fastening of a regulator of pressure, M4; 8 — a casing; 9 — bolts of fastening of a casing; 10 — the generator; 11 — поликлиновой a belt





The design of the generators established on the 2,0-litre engine and engine VR6, is presented on (fig. 334) and (fig. 335) accordingly.

Fig. 335. Details of the generator and its fastening on engine VR6: 1 — bolt М8; 2 — an arm; 3 — a washer; 4 — конусный a bolt, 25 Н·м; 5 — the generator; 6 — a pressure regulator; 7 — bolts of fastening of a regulator of pressure, M4; 8 — a casing; 9 — bolts of fastening of a casing; 10 — поликлиновой a belt; 11 — bolts М8, 25 Н·м; 12 — bolt M8, 25 Н·м; 13 — конусный a bolt, 25 Н·м




Generator removal spend in a following order:
- Remove "minus" a wire from conclusion АБ. Unbend a cable from polar conclusion АБ (to avoid their casual contact);
- Remove приводной поликлиновой a belt;
- Disconnect from outside a generator casing an electric socket and a wire from the separate plug;
- Turn away bolts of fastening of the generator to an arm, take out them and remove the generator.
Generator installation spend in an order, the return to removal. Enclose поликлиновой a belt in flutes of pulleys and adjust its tension.