Repair VW Sharan. Diesel engines: 1,9 l TDI.+ 1. Introduction - 2. Engine VR6 - 2.1. Cнятие and installation 2.1.1. Removal and installation of a transmission from the engine 2.1.2. Additional operations if on the car the conditioner is established 2.1.3. An engine mount + 2.2. Dismantling and assemblage + 2.3. A head of the block of cylinders and valves + 2.4. Pistons and rods 2.5. The block of cylinders + 2.6. A cranked shaft and radical bearings + 2.7. A mechanism drive газораспределения 2.8. An intermediate shaft 2.9. Compression check in engine cylinders + 2.10. System of release of the fulfilled gases + 3. The two-litre engine (ADY) + 4. System of greasing of the engine + 5. Cooling system + 6. System of injection of fuel of engine VR6 + 7. System Simos of injection of fuel of the 2,0-litre engine + 8. Ignition system + 9. Coupling + 10. A mechanical 5-step transmission + 11. Shaft of a drive of wheels + 12. The steering hydraulic booster + 13. A forward suspension bracket + 14. A back suspension bracket + 15. Brake system + 16. An electric equipment + 17. The diesel engine + 18. System of greasing of the diesel engine + 19. System of cooling of the diesel engine + 20. The power supply system of the diesel engine and turbocharger + Maintenance service card + Specifications and characteristics + Electroschemes |
Folksvagen Sharan/Sharan repair>> Engine VR6>> Cнятие and installation>> Engine mount At engine mount replacement use fig. 23—25. Follows поддомкратить engine to unload separate elements of a suspension bracket.
Always observe the moments of an inhaling of bolts of fastening of support of an engine mount. At purchase of details of a suspension bracket and support remember that for a mechanical and automatic transmission they differ.
Engine mount adjustment is required only in the event that the engine and a transmission have been removed, and from the engine and its bearing beam the support has been turned off резинометаллическая. Correctly to establish the engine make the following:
- Turn on, and then again tighten by hand on 5–6 turns bolts of a support of an engine mount;
- Shake the engine forward-back that it was levelled, and tighten bolts and nuts, observing the specified moments of an inhaling (fig. 24 and 25 see).
|
|