Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
- 2. Engine VR6
   - 2.1. Cнятие and installation
      2.1.1. Removal and installation of a transmission from the engine
      2.1.2. Additional operations if on the car the conditioner is established
      2.1.3. An engine mount
   + 2.2. Dismantling and assemblage
   + 2.3. A head of the block of cylinders and valves
   + 2.4. Pistons and rods
   2.5. The block of cylinders
   + 2.6. A cranked shaft and radical bearings
   + 2.7. A mechanism drive газораспределения
   2.8. An intermediate shaft
   2.9. Compression check in engine cylinders
   + 2.10. System of release of the fulfilled gases
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
+ 16. An electric equipment
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes




Folksvagen Sharan/Sharan repair>> Engine VR6>> Cнятие and installation>> Removal and installation of a transmission from the engine
Removal of a transmission from the engine (at the removed power unit) spend as follows:
- Turn away bolts of fastening of a transmission to the engine;
- Together with the assistant separate the engine and a transmission, moving last back, and cautiously take it;

The prevention
The primary shaft of a transmission should not lean against petals диафрагменной springs of a press disk of coupling not to damage them.

Transmission installation spend in an order, the return to removal, paying attention to the following:
- Check up a technical condition of coupling;
- Be convinced of serviceability выжимного the coupling bearing;
- Check up presence of aligning plugs in the block of cylinders;
- Clear and grease with a thin layer шлицы and a neck of a primary shaft of a transmission a small amount of lubricant G 000 100. The quantity of greasing should not exceed the size of a pea;

The prevention
Surpluses of greasing can get on frictional overlays of a conducted disk of coupling and to break its work.

- Include one of transfers of a forward course in a transmission;
- With the assistant accurately get a primary shaft in coupling;
- Screw fastening bolts, together with washers and tighten them, depending on used bolts following moments:
М7       10 Н·м
М8       20 Н·м
М10       60 Н·м
М12       80 Н·м