Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
- 2. Engine VR6
   + 2.1. Cнятие and installation
   + 2.2. Dismantling and assemblage
   + 2.3. A head of the block of cylinders and valves
   + 2.4. Pistons and rods
   2.5. The block of cylinders
   + 2.6. A cranked shaft and radical bearings
   + 2.7. A mechanism drive газораспределения
   2.8. An intermediate shaft
   2.9. Compression check in engine cylinders
   + 2.10. System of release of the fulfilled gases
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
+ 16. An electric equipment
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes

Folksvagen Sharan/Sharan repair>> Engine VR6>> Compression check in engine cylinders
To check up, whether valves densely adjoin, whether piston rings are worn out, whether is available other malfunctions in cylinders, measure a compression in engine cylinders. For this purpose the engine should be heated-up to working temperature.
On engine VR6 the compression control in engine cylinders is connected with some difficulties as for this purpose it is required to remove tips of spark plugs and spark plugs by means of the special tool.
If there is a fear that in one of cylinders a bad compression, that reasonable will address on HUNDRED. Besides if on the car engine VR6 it is possible to choose between HUNDRED «Ford» and «Volkswagen» is established.
On compression size it is possible to draw following conclusions:
- Normal compression 1,0—1,3 МПа
- Border of deterioration 750 кПа.