Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
- 2. Engine VR6
   - 2.1. Cнятие and installation
      2.1.1. Removal and installation of a transmission from the engine
      2.1.2. Additional operations if on the car the conditioner is established
      2.1.3. An engine mount
   + 2.2. Dismantling and assemblage
   + 2.3. A head of the block of cylinders and valves
   + 2.4. Pistons and rods
   2.5. The block of cylinders
   + 2.6. A cranked shaft and radical bearings
   + 2.7. A mechanism drive газораспределения
   2.8. An intermediate shaft
   2.9. Compression check in engine cylinders
   + 2.10. System of release of the fulfilled gases
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
+ 16. An electric equipment
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes




Folksvagen Sharan/Sharan repair>> Engine VR6>> Cнятие and installation>> Additional operations if on the car the conditioner is established
The prevention
In no event it is impossible to open a cooling contour as hit on a coolant skin can lead обморожению.

Specially trained personnel with application of special devices can spend this work only. Only on HUNDRED can be lowered and pressure in the conditioner is again created. If it is necessary to dismantle the engine at the established conditioner remove the air compressor and a wire adhere it sideways so that hoses have not been tense.

The prevention
Conditioner hoses are very sensitive to a break, therefore at compressor removal be very cautious.

To reach the compressor, it is necessary to remove the generator and to disconnect скобы fastenings of hoses for a cooling liquid of the conditioner.