The cover of the distributor of ignition needs to be checked regularly on absence in it of cracks, and also to clear it inside and outside of a coal dust and a moisture. Besides, it is necessary to clean бегунок the ignition distributor. For cleaning use the end of a rag moistened in gasoline.

Service of the distributor of ignition spend in a following order:

- отщелкните clips of a cover of the distributor of ignition, disconnect a cable of "weight" and uncover the ignition distributor together with wires ВН;

- Replace бегунок the ignition distributor if its contacts are erased. At all перетачивайте also do not saw round brass contacts;

- At replacement бегунка the ignition distributor, use only ordered бегунок (only for the 2,0-litre engine). Бегунок it is designated as R1;

- Under бегунком the ignition distributor the dustproof washer is located. It also can be removed;

- At installation of a washer and бегунка of the distributor of ignition pay attention to lock nouses;

- If there are small black hyphens on an inside of a cover of the distributor it specifies in formation of spark categories. They can be scratched out accurately a knife. It is necessary to cover the scratched out surface with nail polish if it is impossible to replace a cover;

- Disconnect all wires ВН from the ignition distributor, clean and check up places of their joining and the ends of wires ВН.

Wires ВН keep clean. Delete a moisture to provide good giving of an electric current in ignition system. Wires ВН cannot be cut off to correct their bad contacts, and it is necessary to replace always. New wire ВН should be ordered only according to number of the spare part for the corresponding engine.