Repair VW Sharan. Diesel engines: 1,9 l TDI.+ 1. Introduction + 2. Engine VR6 + 3. The two-litre engine (ADY) + 4. System of greasing of the engine + 5. Cooling system + 6. System of injection of fuel of engine VR6 + 7. System Simos of injection of fuel of the 2,0-litre engine - 8. Ignition system 8.1. The general description and work of system of ignition + 8.2. The basic knots and details of system of ignition 8.3. Safety measures at work on repair of system of ignition + 8.4. Work on repair and service of system of ignition + 8.5. The distributor of ignition of the 2,0-litre engine 8.6. Adjustment of the moment of ignition of the 2,0-litre engine + 8.7. Spark plugs + 9. Coupling + 10. A mechanical 5-step transmission + 11. Shaft of a drive of wheels + 12. The steering hydraulic booster + 13. A forward suspension bracket + 14. A back suspension bracket + 15. Brake system + 16. An electric equipment + 17. The diesel engine + 18. System of greasing of the diesel engine + 19. System of cooling of the diesel engine + 20. The power supply system of the diesel engine and turbocharger + Maintenance service card + Specifications and characteristics + Electroschemes |
Folksvagen Sharan/Sharan repair>> Ignition system>> Safety measures at work on repair of system of ignition At work on repair and service of system of ignition to avoid traumas and damage of the system, observe following safety measures:
- Never disconnect electric wires and do not touch them if the engine works or it is scrolled by a starter;
- Disconnect and connect electric wires of system of ignition only at the stopped engine. At connection of measuring devices it is necessary to switch off also also ignition;
- Before to disconnect штекерную колодку ЭБУ it is necessary to wait a minimum 20 with the ambassador of deenergizing of ignition. Otherwise it is possible to damage ЭБУ;
- Start-up of the engine by a method «прикуривания» from other car should last no more than 1 mines, at pressure no more than 16,5 In;
- At car towage to avoid damage from ignition system always disconnect штекерную колодку ЭБУ;
- Before carrying out of electrowelding works it is necessary to disconnect wires from АБ and штекерную колодку from ЭБУ;
- Use only recommended wires ВН for ignition system;
- At replacement бегунка the ignition distributor, use only ordered бегунок (only for the 2,0-litre engine). Бегунок it is designated as R1.
|
|