Repair VW Sharan. Diesel engines: 1,9 l TDI.+ 1. Introduction + 2. Engine VR6 + 3. The two-litre engine (ADY) + 4. System of greasing of the engine + 5. Cooling system + 6. System of injection of fuel of engine VR6 + 7. System Simos of injection of fuel of the 2,0-litre engine - 8. Ignition system 8.1. The general description and work of system of ignition + 8.2. The basic knots and details of system of ignition 8.3. Safety measures at work on repair of system of ignition + 8.4. Work on repair and service of system of ignition + 8.5. The distributor of ignition of the 2,0-litre engine 8.6. Adjustment of the moment of ignition of the 2,0-litre engine + 8.7. Spark plugs + 9. Coupling + 10. A mechanical 5-step transmission + 11. Shaft of a drive of wheels + 12. The steering hydraulic booster + 13. A forward suspension bracket + 14. A back suspension bracket + 15. Brake system + 16. An electric equipment + 17. The diesel engine + 18. System of greasing of the diesel engine + 19. System of cooling of the diesel engine + 20. The power supply system of the diesel engine and turbocharger + Maintenance service card + Specifications and characteristics + Electroschemes https://www.shopescort.net/ |
Folksvagen Sharan/Sharan repair>> Ignition system>> Adjustment of the moment of ignition of the 2,0-litre engine Ignition of the 2,0-litre engine is regulated, when the engine idles. Adjustment is understood first of all as correct position of the distributor of ignition as it defines the ignition moment. For check on the car of the moment of ignition on the flywheel case there is a scale with a uvula and a label on a flywheel. One division of a scale corresponds 1 ° turn of a cranked shaft. At label combination on a flywheel with a uvula the piston of the first cylinder is in ВМТ.
Adjustment of the moment of ignition spend in a following order:
- Check up engine idling;
- Connect a clip «+» a stroboscope to the plug «+» АБ, "a weight" clip — with the plug «–» АБ, and a clip of the gauge of a stroboscope attach to wire ВН of the first cylinder;
- Start the engine and direct a blinking stream of light of a stroboscope in лючок flywheel cases. At idling of the engine label position on a flywheel should be in limits from 5 ° to 8 °;
- If it is required to spend adjustment of the moment of ignition ослабьте fastening of the distributor of ignition and turn it so that the ignition moment made 6 °;
- Tighten fastening of the distributor of ignition and again check up installation of the moment of ignition;
- Disconnect stroboscope clips.
More exact installation of the moment of ignition can be spent only by means of the special equipment on HUNDRED.
|
|