Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
- 5. Cooling system
   + 5.1. A cooling liquid
   + 5.2. A radiator and the fan
   + 5.3. The pump of water cooling of the 2,0-litre engine
   - 5.4. The pump of water cooling of engine VR6
      5.4.1. Removal and installation
      5.4.2. Repair of the water pump
   5.5. The thermostat of the 2,0-litre engine
   5.6. Engine VR6 thermostat
   5.7. A poliklinovoj belt
   5.8. The circulating pump of a cooling liquid
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
+ 16. An electric equipment
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes




Folksvagen Sharan/Sharan repair>> Cooling system>> The pump of water cooling of engine VR6>> Repair of the water pump
Engine VR6
The water pump is not subject to repair, therefore at failure detection replace it with the new.
The 2,0-litre engine
The water pump cannot be repaired, therefore in a case in it malfunctions, replace it with the new.

Fig. 188. The pump of water cooling of the 2,0-litre engine in the disassembled kind: 1 — a bolt, 25 Н·м; 2 — a pulley; 3 — a bolt, 10 Н·м; 4 — the water pump; 5 — a lining, replace; 6 — the thermostat; 7 — an O-shaped sealing ring, always on replacement; 8 — the connecting union; 9 — a collar; 10 — a cover of the case of the thermostat; 11 — a pulley поликлинового a belt





For pump replacement turn away the case of the thermostat and take out the thermostat 6 (fig. 188 see). Turn out bolts of 3 fastenings of the pump from its case and remove the pump. Remove a lining 5 between two half of case of the pump. Before tightening the pump to the case, establish a new lining, replace an O-shaped sealing ring of the case of the thermostat. Can be removed and the details shown on (fig. 188 see) are accordingly replaced only.