Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
+ 16. An electric equipment
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
- 19. System of cooling of the diesel engine
   + 19.1. A cooling liquid
   + 19.2. A radiator and the fan
   - 19.3. The pump of a cooling liquid
      19.3.1. Removal and installation
      19.3.2. Repair of the pump of a cooling liquid
      19.3.3. A poliklinovoj belt
   19.4. The thermostat
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes




Folksvagen Sharan/Sharan repair>> System of cooling of the diesel engine>> The pump of a cooling liquid>> Repair of the pump of a cooling liquid

Fig. 468. The pump of a cooling liquid: 1 — a bolt, 20 Н·м; 2 — the pump of a cooling liquid; 3 — a bolt, 10 Н·м; 4 — a bolt, 10 Н·м; 5 — the gauge of temperature of a cooling liquid, 7 Н·м; 6 — the thermostat; 7 — a bolt, 10 Н·м; A — it is attached to a head of the block of cylinders; B — to the heat exchanger; C — to a heater radiator; D — from a radiator





The pump of a cooling liquid is not subject to repair, therefore in case of malfunction replace it. Check up the pump on leak presence (leak places are noted by a rust more often) and turn a nave to check up a bearing condition. For pump replacement disconnect the thermostat case (fig. 468 see) and take out the thermostat. Turn away bolts of the pump and remove the pump. Remove a lining between two half of case of the pump.
Before pump installation establish a new lining. Replace a sealing ring of the case of the thermostat.