Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
- 16. An electric equipment
   + 16.1. The storage battery
   + 16.2. The generator
   + 16.3. A starter
   - 16.4. Screen wipers
      16.4.1. Replacement of the lever of a screen wiper
      16.4.2. Replacement of a rubber tape of a brush and replacement of the brush of a screen wiper
      16.4.3. Replacement of a motor-reducer of a screen wiper
   + 16.5. Headlights
   16.6. Back lanterns
   16.7. Replacement of lamps of forward indexes of turn
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes

Folksvagen Sharan/Sharan repair>> Electric equipment>> Screen wipers>> Replacement of the lever of a screen wiper
Replacement of the lever of a screen wiper spend in a following order:
- Switch off a screen wiper;
- Shift a safety cover and ослабьте, become visible, шестигранную a nut (do not turn on it completely);
- Shake the brush lever forward-back so that it was liberated;
- Now completely turn away a nut and cautiously pull together the brush lever;
- Put on the new lever of a brush in correct position and put it on glass;

Fig. 346. Definition "correct" position of brushes of a screen wiper rather each other and a windscreen bottom edge

- Check up correctness of installation of a new brush for what measure distance And and In (fig. 346). If interval A makes 20 mm, and interval B = 45 mm the brush lever costs in correct position;
- Tighten шестигранную a nut the moment 20 Нм;
- Include a screen wiper and be convinced that screen wiper brushes at its work constantly come back in correct position;
- Establish a safety cover on a former place.