Repair VW Sharan. Diesel engines: 1,9 l TDI.+ 1. Introduction + 2. Engine VR6 + 3. The two-litre engine (ADY) + 4. System of greasing of the engine + 5. Cooling system + 6. System of injection of fuel of engine VR6 + 7. System Simos of injection of fuel of the 2,0-litre engine + 8. Ignition system + 9. Coupling + 10. A mechanical 5-step transmission + 11. Shaft of a drive of wheels + 12. The steering hydraulic booster - 13. A forward suspension bracket 13.1. Removal and installation - 13.2. Repair of a forward suspension bracket 13.2.1. A screw spring and the shock-absorber 13.2.2. Replacement of bearings of wheels 13.2.3. Removal and installation of cross-section levers 13.3. The stabilizer of cross-section stability + 13.4. Adjustment of corners of installation of forward wheels + 14. A back suspension bracket + 15. Brake system + 16. An electric equipment + 17. The diesel engine + 18. System of greasing of the diesel engine + 19. System of cooling of the diesel engine + 20. The power supply system of the diesel engine and turbocharger + Maintenance service card + Specifications and characteristics + Electroschemes |
Folksvagen Sharan/Sharan repair>> Forward suspension bracket>> Repair of a forward suspension bracket>> Replacement of bearings of wheels If you remove the wheel bearing it will collapse. Therefore it is impossible выпрессовывать the bearing of a wheel for check of its condition.
To remove the case of the bearing of a wheel, item 13.1 see. After removal of the case of the bearing turn on or the bolts fastening a spherical support, or disconnect it. Remove амортизаторную a rack from a rotary fist;
- After removal of the case of the bearing of a wheel make adjustment of corners of installation of forward wheels.
Replacement procedure of the bearing of a wheel:
- Remove a disk of the brake mechanism (bolt) and a reflector of a rotary fist (3 bolts);
- Put a rotary fist with a nave of a wheel the forward party downwards on a press and squeeze out a wheel nave with the help оправки the press through the wheel bearing. The way of installation оправки is shown in drawing 289. The effort can be applied only on an underside of a nave of a wheel;
- Carefully clear an inside of an aperture of the bearing and take a lock ring of the bearing of a wheel (nippers for removal of lock rings);
- In position of a rotary fist on a press (fig. 289 see) squeeze out the wheel bearing outside. Use for this purpose оправку which has the size corresponding to an external ring of the bearing of a wheel;
- Squeeze out an internal ring of the bearing of a wheel with the help двухзахватного a stripper (fig. 290);
- Carefully clear a rotary fist. A reception aperture of a rotary fist cover with graphitic greasing Molykote.
Assembly order:
- Put the case of the bearing of a wheel on a press (fig. 289), впрессуйте the bearing see and establish a lock ring;
- Put a nave on a press and впрессуйте the case of the bearing of a wheel with the bearing established in it in a nave. Use for this purpose the pipe piece which diameter corresponds to internal diameter of the bearing, that напрессовать the case of the bearing of a wheel and the wheel bearing against the stop on a wheel nave;
- Other works spend in return sequence concerning removal process.
|
|