For removal of cross-section steering draught remove the ball hinge gear рейки. The special key (№ 1332/8) or enough big wrench is for this purpose used.

Fig. 268. Length of cross-section steering draught (the size a)

Measure length of all cross-section steering draught, including a head of cross-section steering draught (distance an on fig. 268). The nominal size makes 378,5±1,0 mm;

- Release a cover of the hinge and shift it back on cross-section steering draught;

Fig. 269. Removal of the spherical hinge of cross-section steering draught with gear рейки. On a key 1 (1332/8) establish динамометрический a key 2 (1332)

- Clamp the steering mechanism in a vice (fig. 269) and establish the key represented there on the spherical hinge of cross-section steering draught. Remove cross-section steering draught;

- Establish new cross-section steering draught, maintaining the distance measured earlier, and again twist it in gear рейку the moment of an inhaling 70 Н·м. Do not put a liquid fixing carving connection, on a carving of cross-section steering draught;

- Establish a hinge cover on the case gear рейки.

- Adjust a descent-disorder of forward wheels.