Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
- 12. The steering hydraulic booster
   + 12.1. A steering drive
   - 12.2. Replacement of cross-section steering draughts
      12.2.1. Replacement of a head of cross-section steering draught
      12.2.2. Replacement of all cross-section steering draught
   + 12.3. Hydraulic system
   12.4. Hoses, pipelines
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
+ 16. An electric equipment
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes




Folksvagen Sharan/Sharan repair>> The steering hydraulic booster>> Replacement of cross-section steering draughts>> Replacement of a head of cross-section steering draught
After replacement of cross-section steering draught or a head of cross-section steering draught spend adjustment of a descent-disorder of wheels:
- Remove a forward wheel;
- Keeping cross-section steering draught for шестигранник, fix it in motionless position. Ослабьте a counternut of cross-section steering draught;

Fig. 264. Removal of a spherical support of cross-section steering draught





- Turn away a nut of fastening of a head of cross-section steering draught on сошке a wheel and a stripper separate connection (fig. 264 see);
- Remove a head of cross-section steering draught, considering thus quantity of turns which were required for its removal;
- If it is necessary to replace a hinge cover:
- Remove collars and pull together the goffered cover;
- Put on a new cover the acting end of cross-section steering draught and establish on it new collars. After that it is required to spend adjustment of a descent-disorder of wheels;
- Establish a new head of cross-section steering draught and wrap it on that quantities of turns on which the old has been twirled;
- Clear a bolt of a head of cross-section steering draught and insert it in сошку a wheel. Put on it new самоконтрящуюся a nut and tighten its moment 30 Н·м. From final position tighten it for 90 °;
- Inspect a descent-disorder of forward wheels (section 13 «Forward suspension bracket» see). Pay attention to that the safety goffered cover has not been braided. Tighten a counternut on an inside of the hinge of cross-section steering draught the moment 55 Н·м.