Repair VW Sharan. Diesel engines: 1,9 l TDI.+ 1. Introduction + 2. Engine VR6 + 3. The two-litre engine (ADY) + 4. System of greasing of the engine + 5. Cooling system + 6. System of injection of fuel of engine VR6 + 7. System Simos of injection of fuel of the 2,0-litre engine + 8. Ignition system + 9. Coupling + 10. A mechanical 5-step transmission + 11. Shaft of a drive of wheels + 12. The steering hydraulic booster - 13. A forward suspension bracket 13.1. Removal and installation + 13.2. Repair of a forward suspension bracket 13.3. The stabilizer of cross-section stability - 13.4. Adjustment of corners of installation of forward wheels 13.4.1. A convergence of wheels 13.4.2. A corner of disorder of a wheel 13.4.3. A corner of a longitudinal inclination of an axis of turn + 14. A back suspension bracket + 15. Brake system + 16. An electric equipment + 17. The diesel engine + 18. System of greasing of the diesel engine + 19. System of cooling of the diesel engine + 20. The power supply system of the diesel engine and turbocharger + Maintenance service card + Specifications and characteristics + Electroschemes |
Folksvagen Sharan/Sharan repair>> Forward suspension bracket>> Adjustment of corners of installation of forward wheels>> Convergence of wheels The convergence of wheels can be regulated on cross-section steering draughts instead of as was earlier on Volkswagen where it was possible to make adjustment only on the left cross-section steering draught. A convergence of wheels measure in the usual way, and it is necessary to pay attention that values are given in degrees and minutes. Wheels should stand freely. Digital value of a convergence is specified in the table of adjustments and the control.
The steering should stand precisely on the average position (movement on a straight line). For adjustment of a convergence of wheels ослабьте counternuts from both parties of the car, located on tips of cross-section steering draughts. Not to allow to be turned to a protective cover of a steering, ослабьте a collar from an outer side.
Rotate cross-section steering draught flat-nose pliers to the left or to the right. Both pipes of cross-section steering draughts move on identical size that the steering wheel remains in the central position. Tighten counternuts of tips of cross-section steering draughts the moment 55 Н·м and again fix protective covers.
|
|