Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
- 9. Coupling
   9.1. Coupling removal
   9.2. Check of a technical condition and the coupling control
   9.3. Coupling installation
   + 9.4. A drive of deenergizing of coupling
   9.5. Malfunctions of coupling
+ 10. A mechanical 5-step transmission
+ 11. Shaft of a drive of wheels
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
+ 16. An electric equipment
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes

Folksvagen Sharan/Sharan repair>> Coupling>> Coupling installation
Coupling installation is spent in return sequence taking into account the following:
- If establish old coupling watch that all earlier put labels have coincided. New coupling can be established in any position as it has not got used yet;

Fig. 230. A centering of a conducted disk

- To a centering of a conducted disk concerning a flywheel it is applied, simulating шлицевой the end of a primary shaft of a transmission, оправка VW 3190 (fig. 230). For a centering it is possible to use an old primary shaft of a transmission;
- Bolts of fastening of a casing of coupling to a flywheel wrap in regular intervals cross-wise and tighten their moment 25 Н·м. Thus the flywheel should be stopped a clamp in motionless position. On HUNDRED «Volkswagen» clamp VW 3067 (fig. 230 see) is for this purpose used;
- After installation on the transmission engine, check up quality of work of coupling.