Service, the device and Folksvagen Sharan repair - 11.1.1. On the car with a mechanical transmission

Repair VW Sharan

. Diesel engines: 1,9 l TDI.
+ 1. Introduction
+ 2. Engine VR6
+ 3. The two-litre engine (ADY)
+ 4. System of greasing of the engine
+ 5. Cooling system
+ 6. System of injection of fuel of engine VR6
+ 7. System Simos of injection of fuel of the 2,0-litre engine
+ 8. Ignition system
+ 9. Coupling
+ 10. A mechanical 5-step transmission
- 11. Shaft of a drive of wheels
   - 11.1. Removal and power shaft installation
      11.1.1. On the car with a mechanical transmission
      11.1.2. On the car with an automatic transmission
   11.2. Power shaft repair
+ 12. The steering hydraulic booster
+ 13. A forward suspension bracket
+ 14. A back suspension bracket
+ 15. Brake system
+ 16. An electric equipment
+ 17. The diesel engine
+ 18. System of greasing of the diesel engine
+ 19. System of cooling of the diesel engine
+ 20. The power supply system of the diesel engine and turbocharger
+ Maintenance service card
+ Specifications and characteristics
+ Electroschemes

Folksvagen Sharan/Sharan repair>> Shaft of a drive of wheels>> Removal and power shaft installation>> On the car with a mechanical transmission

Remove a decorative cap of a wheel and turn away bolts of fastening of a wheel;

- Will hang out a forward part of the car;

- Remove a wheel;

- Having fixed a wheel nave in motionless position, turn away a bolt of fastening of a shaft.

Removal of the left power shaft

Remove engine protection;

- Separate steering draught with the lever on a rotary fist;

- Disconnect draught of the stabilizer of cross-section stability from амортизаторной racks;

Fig. 259. The spherical support fastens to a rotary fist in a place specified by an arrow

- Turn away two bolts located in the bottom part of a rotary fist (fig. 259). Unbend a head of an axis with амортизаторной racks outside and fix in motionless position. To avoid damages, disconnect a brake hose and distributing of wires of the gauge of frequency of rotation ABS from fastening on амортизаторной to a rack;

Fig. 243. Power shaft extraction

- Short jerk pull out a power shaft from a transmission (fig. 243 see), it is possible to take advantage of mount;

Fig. 260. To extend a power shaft from gearing with the case of the bearing of a nave of a wheel, shift the case of the bearing of a wheel outside, simultaneously having pulled a power shaft in an opposite direction

- Turn out a bolt from a semiaxis end face, and then squeeze out and take полуось from a wheel nave (fig. 260). Do not bend the hinge too strongly, the corner on which it can be bent should not be more than 18 �.